Ross CrossOver 6 Manuale dell'Operatore Scaricare il pdf (Pagina 50)

4–8 • Advanced Operation CrossOver 6 / 12 User Manual (v4.0)

Note:

• If no GPI banks are configured as outputs, you can

not select s GPI output in step 5 above.

• If the selected GPI output is configured as a level

trigger, it remains in the latched state until you

unlatch it.

For More Information on...

• configuring GPI banks, refer to the section

“General Purpose Interface (GPI)” on page 4-14.

To apply an offset to LTC timecode data:

1. Press MENU.

2. Press the SYSTEM Wipe Pattern button.

3. Press NEXT until Config LivEDL is

displayed.

4. Press the Config LivEDL knob to display

the EDL Configuration menu.

5. Press NEXT until LTCOff is displayed.

6. Use the LTCOff knob to select an offset (in

frames) to apply to the LTC timecode.

Note:

• LTC offsets are only available if you are using a

GearLite TSC-9902 LTC to Serial Converter.

Capturing EDL Data

Capturing EDL data is manually started and stopped.

You can retrieve EDL files via an FTP connection or

by saving them to a USB drive. You can delete EDL

files from the switcher to free space for more data

capture.



It is strongly recommended that you use a GearLite

TSC-9902 LTC to Serial Converter to provide

timecode information when capturing EDL data.

To start capturing an EDL file:

1. Press MENU.

2. Press the USER Wipe Pattern button.

3. Press the LiveEDL knob to display the

LiveEDL menu.

4. Use the left knob to select the EDL file you

wish to capture to.

5. Press the Start knob.

Note:

• A maximum of 999 EDL files may be present on

the switcher.

For More Information on...

• installation and configuration of the TSC-9902

LTC to Serial Converter, refer to your TSC-9902

documentation.

To stop capturing an EDL file:

1. Press MENU.

2. Press the USER Wipe Pattern button.

3. Press the LiveEDL knob to display the

LiveEDL menu.

4. Press the Stop knob.

Saving, Deleting, and Accessing EDL Files

You can save captured EDL files to a USB drive,

delete files from the switcher to make room for more

data capture, and access EDL files stored internally

on the switcher via an FTP connection.

To save or delete a captured EDL file

1. Insert a USB drive into the USB port if you are

saving EDL files.

2. Press MENU.

3. Press the USER Wipe Pattern button.

4. Press the LiveEDL knob to display the

LiveEDL menu.

5. Use the left knob to select the EDL file you

wish to save or delete.

6. Save or delete the EDL file by performing one

of the following:

• Press the Save knob to save the EDL file

to a USB drive connected to your switcher.

• Press the Delete knob to delete the EDL

file.

7. Press the Confrm knob to perform the save

or delete. Press the Cancel knob to cancel

the save or delete.

Note:

• Wait 5 seconds after inserting a USB drive into the

USB port before using it.

• If you select a file that has no captured EDL data,

the save and delete options are not available.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 85 86

Commenti su questo manuale

Nessun commento

Ross CrossOver 6 Manuale dell'Operatore Pagina 50

Commenti su questo manuale

Prodotti e manuali riguardandi Schede madri Ross CrossOver 6